Yeti Cycles 160E T1 TURQ Carbon 29" E-Mountain Bike
The Yeti Cycles 160E T1 29" E-Mountain Bike made of TURQ Carbon for Enduro Trails
The 160E T1 with high-quality TURQ carbon and Shimano XT equipment is the first e-mountain bike from Yeti Cycles and impresses on enduro race tracks with its newly-developed Sixfinity linkage design and high efficiency.
Information regarding the return of batteries and electrical equipment:
Information on the return and disposal of used batteries and electrical equipment can be found here. For information regarding the return of used e-bike batteries, please contact our customer service.Guidelines for Replacing E-bike Components:
Before you replace components on your e-bike, please read through the guidelines for component replacement for CE-marked e-bikes/pedelecs with pedal assistance.Specifications:
- Application:
- Enduro
- Wheel Size:
- 29"
- Front Travel:
- 170 mm
- Rear Travel:
- 160 mm
- Sizes:
- S, M, L, XL
- Front Triangle Material:
- Carbon (TURQ Series)
- Rear Triangle Material:
- Carbon (TURQ Series)
E-Motor:
- Type:
- mid-drive motor
- Motor Type:
- Shimano EP8
- Pedal Assist (max.):
- 25 km/h
- Power:
- 250 W
- Battery Type:
- Shimano internal
- Capacity:
- 630 Wh
- Display:
- Shimano EM800
Components:
- Frame:
- Yeti Cycles 160E
- Fork:
- Fox Racing Shox 38 Factory E-Tune, GRIP2
- Stem:
- Burgtec Enduro MK3, 35 mm, 50 mm
- Handlebars:
- Yeti Cycles E-Bike Carbon, 35 mm, 800 mm
- Grips:
- ODI Elite Pro
- Rear Shock:
- Fox Racing Shox Float X2 Factory
- Remote System:
- none
- Headset:
- Cane Creek 110 integrated
- Seatpost:
- SRAM Reverb AXS 31.6 mm, 150 mm (M), 175 mm (L, XL)
- Saddle:
- WTB Silverado Custom
- Crank:
- Shimano EM900, 34 T, 160 mm
- Pedals:
- none
- Brakes:
- SRAM Code RSC, SRAM Centerline brake rotors 220 mm / 200 mm
- Shift Lever:
- Shimano XT, 12-speed
- Rear Derailleur:
- Shimano XT, 12-speed
- Cassette:
- Shimano XT, 10-51 T
- Chain:
- Shimano XT, 12-speed
- Rims:
- DT Swiss EX1700, 30 mm
- Spokes:
- DT Swiss
- Front Hub:
- DT Swiss
- Rear Hub:
- DT Swiss
- Front Tyre:
- Maxxis Assegai 29 x 2.5" EXO+
- Rear Tyre:
- Maxxis Minion DHR II 29 x 2.4" DD
Approved For:
- Rotor Size (max.):
- 220 mm (rear)
- Tyre Size (max.):
- 29 x 2.6"
- Chainrings:
- 1x
- Chainring Size (max.):
- 1x 34-tooth
Features:
- newly developed Sixfinity suspension for e-drivetrains
- adjustment of the progressivity of the transmission ratio is possible
- little anti-squat deviation in SAG across the entire cassette for pedalling efficiency in every gear
- semi-integrated battery needs approx. 5 hours charging time
- Bluetooth connection to Shimano E-tube apps is possible
- OneUp Components chain guide keeps cables in place as well as the chain
- short chainstays for traction and agile rear end at high speed
- higher bottom bracket and shorter crank than the SB150 for more pedalling freedom
- Fox Float X2 Factory rear shock with custom tune and sensitive response
- clever, completely internally routed cable routing and management on the cockpit, without cable hammering at entry and exit openings
- straight, continuous seat tube enables the use of Vario seatposts with a lot of travel
- optimised chainstay protection against noise caused by chain slap
Technology:
SixfinityThe Sixfinity linkage design was developed specifically for the requirements of e-mountain bikes. At the beginning of the travel, the Switch Link shifts upwards, then as the travel increases, it lowers again from a specific turning point. This creates an anti-squat curve that allows efficient pedalling in any gear, unlike non-motorised bikes where anti-squat has a higher relevance in smaller gears. The Sixfinity construction also allows for three ratio progressivity settings without affecting geometry, anti-squat or anti-rise, and with minimal change in travel. So you have the choice between a rather calm, balanced or poppy character.
Geometry:
S:- Recommended Height:
- 155 - 170 cm
- Stack:
- 617.0 mm
- Reach:
- 430.0 mm
- Seat Tube Length:
- 380.0 mm
- Effective Top Tube Length:
- 560.9 mm
- Head Tube Length:
- 95.0 mm
- Chainstay Length:
- 446.0 mm
- Wheelbase:
- 1208.3 mm
- Bottom Bracket Height:
- 350.0 mm
- Seat Tube Angle:
- 78.0°
- Head Tube Angle:
- 64.5°
- Standover Height:
- 754.0 mm
M:
- Recommended Height:
- 165 - 180 cm
- Stack:
- 620.0 mm
- Reach:
- 460.0 mm
- Seat Tube Length:
- 410.0 mm
- Effective Top Tube Length:
- 591.8 mm
- Head Tube Length:
- 98.3 mm
- Chainstay Length:
- 446.0 mm
- Wheelbase:
- 1239.7 mm
- Bottom Bracket Height:
- 350.0 mm
- Seat Tube Angle:
- 78.0°
- Head Tube Angle:
- 64.5°
- Standover Height:
- 754.0 mm
L:
- Recommended Height:
- 178 - 191 cm
- Stack:
- 625.0 mm
- Reach:
- 480.0 mm
- Seat Tube Length:
- 450.0 mm
- Effective Top Tube Length:
- 613.4 mm
- Head Tube Length:
- 103.8 mm
- Chainstay Length:
- 446.0 mm
- Wheelbase:
- 1262.1 mm
- Bottom Bracket Height:
- 350.0 mm
- Seat Tube Angle:
- 78.0°
- Head Tube Angle:
- 64.5°
- Standover Height:
- 754.0 mm
XL:
- Recommended Height:
- 185 - 201 cm
- Stack:
- 635.0 mm
- Reach:
- 505.0 mm
- Seat Tube Length:
- 495.0 mm
- Effective Top Tube Length:
- 641.5 mm
- Head Tube Length:
- 114.9 mm
- Chainstay Length:
- 446.0 mm
- Wheelbase:
- 1291.9 mm
- Bottom Bracket Height:
- 350.0 mm
- Seat Tube Angle:
- 78.0°
- Head Tube Angle:
- 64.5°
- Standover Height:
- 754.0 mm
Manufacturer Numbers:
- turquoise / S:
- YCB22160ESMPTUX2T018700
- turquoise / M:
- YCB22160EMDPTUX2T018700
- turquoise / L:
- YCB22160ELGPTUX2T018700
- turquoise / XL:
- YCB22160EXLPTUX2T018700
Shipping Notice:
The shipment is sent pre-assembled by a forwarding agent.The delivery time is extended by 2-5 days, depending on the overall volume of orders.
For individual consultation, please contact our customer service team.
Contents:
- 1 x Yeti Cycles 160E T1 TURQ Carbon 29" e-bike
- 100 day return period
- Online since 1998