bc basic Tubeless Valves - 2 Pack

Does not fit to some rims. Had to tighten them very hard until they stop loosing air (tubeless tape was present, additional layer didn't help). Be careful before buying and check the shape of your rims. For the rest is a good valves.

Pretty good valves for the value. One didn't seal correctly for a while but after I got it tightened enough it worked since. Will buy again!

high quality and somewhat good finish for the price other ludicrous priced companies sell a couple of valve heads! buy with confidence

They work very well at my tubeless rims. Handy to be able to screw the top part out to be able to have a big amount of air to be pressed through it so a new tire will inflate. Many times I couldn't inflate it without getting the top-piece of.

I set up my new set of tubeless CX wheels with these valves. I've used 1 layer of the bike-components basic tubeless tape, which is no longer available. The tires held the air nicely after I've added Stans sealant, and have been going strong for 2 months.

I would definitely recommend these valves.

Превосходный бескамерный клапан, чем то конструктивно похож на клапан от SCHWALBE, тоже кстати не плохой, но этот bc просто супер, надежный нипель, ну и цена не большая.

Fit well with stans rim tape or gorilla tape (duck), I tested on both. A good pair of valves.

The rubber valve hole block is quite small and doesn't fit all rims. It took me a lot of time to install tubeless tires as leakages through the valve hole kept occurring. In the end I put a small piece of inner tube with a hole over the valve to be able to get a better fit between valve block and valve hole. After that it was fine but be aware it might not be a good fit for all rims.

Does the job what is should be doing

Fait le job sans problemes