BEAST Components Gravel Bar IR 31.8 Carbon Handlebars

The Gravel Bar IR 31.8 carbon handlebars from BEAST Components for a high-end cockpit

The Gravel Bar IR by BEAST Components is made of carbon and is suitable for all those who value high performance on their gravel bikes. Interface Reinforcement increases the durability of contact points with other components, such as the stem. The handlebars offer you a full 24° of flare. This gives you optimum control of your gravel bike even in the drops. When the going gets tough, you'll be back in the hoods in no time thanks to the low 110mm drop.

Specifications:

Application:

Gravel

Width:

400 mm, 420 mm, 440 mm, 460 mm (centre-centre)

Note:

With BEAST Components, the handlebar width is measured in the centre of the shift/brake lever attachment.

Stem Clamp:

31.8 mm

Technical Information:

Drop:

110 mm

Reach:

80 mm

Backsweep:

4°

Flare:

24°

Cable Routing:

external

Material:

carbon

Approved For:

Stem Clamp Width:

100 mm

Features:

• carbon handlebars for high-performance gravel bikes
• increased safety compared to the predecessor due to Interface Reinforcement at all contact points
• low 110 mm drop
• tube diameter of the 40 cm variant adapted for small hands
• handmade in Germany

Technology:

Intended Use Category 3
Suitable for use on paths, such as paved and unpaved hiking trails, where roots, thresholds, stones and steps are found frequently, but the wheels are in constant contact with the ground or lose contact with the ground for short periods due to uneven surfaces such as roots. Steps of up to 15 cm, e.g. kerbs, can be ridden down.

Interface Reinforcement
The contact points of handlebars and seatposts are covered with a protective layer. This withstands punctual loads and higher tightening torques. It also compensates for higher tolerances.

Manufacturer Numbers:

40 cm:

GB31400US2

42 cm:

GB31420US2

44 cm:

GB31440US2

46 cm:

GB31460US2

Contents:

• 1 x BEAST Components Gravel Bar IR 31.8 handlebars