OneUp Components Switch Chainring

The OneUp Components Switch Chainring almost changes itself

The OneUp Components Switch chainring is an essential part of the Switch Direct Mount chainring system, which stands for greatly simplified and accelerated chainring changes. Only a 4 mm Allen key is required to complete the set-up in the shortest possible time and the crank does not need to be removed. So if a steep trail gets in your way, you can switch to a smaller chainring in the parking lot. The Switch chainrings are uncompromisingly optimised and have already been successfully tested on the Enduro World Series. Their narrow-wide structure prevents the chain from dropping. And you'll save money with them too, because a OneUp Components Switch replacement chainring costs less than a new Direct Mount chainring.

Specifications:

Application:

Enduro, All Mountain

Attachment:

OneUp Components Switch

Teeth:

28 T, 30 T, 32 T, 34 T

Gearing:

1x9-speed, 1x10-speed, 1x11-speed, 1x12-speed

Technical Information:

Material:

aluminium (7075-T6)

Compatibility:

• SRAM 9-/10-/11-/12-speed chains
• not compatible with Shimano 12-speed chains
• only can be used in conjunction with the OneUp Components Switch Carrier Spider

Features:

• chainring swap in under a minute (manufacturer specification)
• quick setup adjustments depending on the circumstances
• less cost for spare chainrings
• requires only a 4 mm hex key, cranks don't need to be removed

Note:

Loosen bolts with two turns, loosen and remove chainring with a 20° rotation. To install the new Switch chainring, proceed in the opposite direction, 8 Nm tightening torque.

Manufacturer Numbers:

28 tooth:

1C0391BLK

30 tooth:

1C0392BLK

32 tooth:

1C0393BLK

34 tooth:

1C0394BLK

36 tooth:

1C0395BLK

Contents:

• 1 x OneUp Components Switch chainring